After upgrading to version 9 - everything is good except when I try to use the cog wheel GUI to access the Voretexbox info I get
HDDTemp error: 111, Connection refused
Everything else works OK
What do I do?
After upgrading to version 9 - everything is good except when I try to use the cog wheel GUI to access the Voretexbox info I get
HDDTemp error: 111, Connection refused
Everything else works OK
What do I do?
Bump
As far as I can tell (lots of Google) - this might have to do with firewalls - but i have not changes anything and looking at it is seems OK. Is there any way I can reinstall Hddtemp and/or phpsysinfo ? Or try this from the command line in the VBA?
The broswer has http://192.168.1.100/phpsysinfo/ at the top then the connection refused error.
have you tried
yum install hddtemp
reboot
Triied that - still no good (also tried to install phpsysinfo but no package found)
OK - now I am confused - looking around it says here http://vortexbox.org/documenta.....lmsensors/
that since I have a VortexBox appliance that this should NOT work (HDDtemp) - but if I go to the command line and do
hddtemp /dev/sda
I do get a temp (/dev/sda: WDC WD10EADS-00L5B1: 35°C)
For that matter why is phpsysinfo even looking for hddtemp - if it doesn't (shouldn't?) work on the VBA?
Posting Permissions
Reply With Quote
Bookmarks