Search:

I will be without internet access for a period of time and still trying to get prepared for it using just a home lan (wired/wireless) Is there anyway to access the org vortexbox interface so I can...

Thanks to everyone. Belkin said the router should be reset back to factory settings and then to connect the wired and then the wireless using the passwords and it will work. Being without the...

No they are separate. I will try Belkin Support as if it worked for you there must be away to set this router. You have given me hope even if I have to get a different router. thank you

Thanks, I will try it out. Didn't know if the router would have to be reset internally to allow the change if it was possible. The last time the internet went dead the router status light went to red...

Wii be without internet connection for a couple of years. Is there anyway to set up the router to connect wireless and wired to components in the home? I would like to use the vortex box device....

Hi, I just replaced my 1T drive with a WD red series (red series made for NAS) 3T so am fresh with how to. After removing top, I am assuming you did. You just take two screws out (next to the HD/DVD...

Sorry to confuse! BUT I know now I created a problem that was not there. I misunderstood Ron Olsen's very good instructions on the 3T hd partion set up (which went flawlessly) and then the ISO...

All fixed. Thank you Andrew for your help. Put the old HD back in and then changed the ip adress off of static. Put the new drive in and now all ok. Put the static ip back on and now putting the...

Changed nothing. The DHCP is still on on the VB config. But I did put a static ip address in The VB GUI when I had the original HD in the VB prior to the HD switch and ISO install. I have played...

:( VB boots up and then goes through its cks etc and gives message cannot connect to eth0. So I followed forum members suggestions to ifconfig etho and it takes the ip addr in put: ip addr add...

How long does it take for the VB ISO disc to load on a newly formated vortexbox device? I installed a 3T hd and formated it per Ron Olsen's post and that all went well. Then followed the next step...

Thanks durks. In the mean time Andrew answered my e=mail and indicated all my boot info is on old drive. So now have to download The ISO software and install it. Hope this works the same as...

Ok, bought a monitor and hooked the VB up. Get the bios screen and imeadiately get message "reboot select proper boot device or insert boot media in selected boot device and press key". Is the boot...

thanks for steps. I do not have ready access to monitor as working with windows 7 & 8 laptops. May have to borrow one if I can't get it up and running. I installed Cryto term and it trys to connect...

Was filling up the 1T drive in Vortexbox so got a new 3T red series HD from WD. The install went fine and the box turned on and the internet connection light lit up Also lan connection on back has...